Support Center > Knowledge base> Article: Aligning the CO2 Laser in the Fusion Edge

Aligning the CO2 Laser in the Fusion Edge

Article ID: 106801 Print
Question
How do I align the CO2 laser in my Fusion Edge?

Answer

The instructions below show how to align the CO2 laser in the following models: Fusion Edge 12, 24 & 36, Fusion Pro 24 & 36.

 

Note: this procedure is for CO2 models only and is not intended for use on fiber and/or dual source models.

 

17000 - Fusion Edge CO2 Alignment.pdf

 

If further assistance is needed, please reach out to Epilog Tech Support by phone at 303-215-9171, or email at tech@epiloglaser.com.

 

 


related articles

Article Details
156 Created on: Apr 18, 2022
Date updated: Apr 18, 2022
Tagged: align, laser, fusion


Poor Outstanding