Support Center > Knowledge base> Tagged: rotary
Tag: rotary
5 Articles
Orange arrow How do I set up wrap-around artwork when engraving with the rotary attachment?

22153 views
  How to Set Up Artwork for Engraving with the Rotary Attachment Using your rotary attachment to create 360 degree engravings will give even more versatility to your Epilog laser system. Setting up the artwork to wrap around an object is very simple. In this exercise we will be using The Torch MAG-L...
Tagged: rotary


Orange arrow What is the maximum diameter/length that will fit on the Rotary Attachment?

9064 views
  Maximum diameter that will fit on the Rotary Attachment for each system Epilog Zing 24: 5.25" (133mm) Epilog Mini 18: 3" (76mm) Epilog Mini 24: 5" (127mm) Epilog Helix: 8" (203mm) Fusion 32: 10.75" (273 mm) Fusion 40: 10.75" (273 mm) FiberMark Rotary Attachment Diameter Capabilities ...
Tagged: rotary, diameter


Orange arrow How do I install the Fusion 3-Jaw Chuck Rotary Attachment?

391 views
  How do I install the Fusion 3-Jaw Chuck Rotary Attachment? Click the link below for instructions: https://www.epiloglaser.com/assets/downloads/tech-support/3-Jaw.pdf...
Orange arrow How do I replace the Fusion rotary motor?

229 views
  How do I replace the Fusion rotary motor? Click the link below for instructions: https://www.epiloglaser.com/assets/downloads/tech-support/Rotary-motor-Fusion.pdf...
Orange arrow How do I fix the vertical vector lines on the Fusion?

255 views
  How do I fix the vertical vector lines on the Fusion? Click the link below for instructions: https://www.epiloglaser.com/assets/downloads/tech-support/Fusion-Vertical-Lines-Rotary.pdf...
Posted in: Fusion


Page: 1 of 1