Support Center > Knowledge base> Tagged: replacing
Tag: replacing
7 Articles
Orange arrow How do I replace the control board on my Mini or Helix system?

20477 views
  Control Board Replacement on the Mini and Helix Systems Machine Types: Epilog Mini 18/24, Helix Tools needed: #1 & #2 Phillips head screwdrivers Note: If you are printing through the Ethernet port it is important that you retrieve the parameter for the IP Address, Subnet Mask and Gateway fr...
Orange arrow How do I replace the power supply on my Epilog Zing?

8809 views
  Power Supply Replacement for the Epilog Zing Machine Type: Epilog Zing 16 and 24 Laser Tools Required: Phillips screw driver Lower the table to the bottom of the machine using the focus buttons on the display. Disconnect the machine from its power source. Remove the power cor...
Posted in: Epilog Zing

Orange arrow How do I replace the laser tube in my Epilog Mini or Helix?

27109 views
  Laser Tube Replacement in the Epilog Mini and Helix Machine Types: Epilog Mini 18/24 and Helix Tools needed: Phillips head screwdriver #1 Turn off and unplug the laser system. Facing the back of the machine, remove the 9 screws using the Phillips head screwdriver on the back panel. The l...
Orange arrow How do I remove the X-Axis assembly and reinstall the new one in the Zing Laser?

13536 views
  X-Axis Assembly Removal and Installation for the Epilog Zing Machine Type: Epilog Zing 16 and 24 Tools Required: Phillips screw driver Disconnect the machine from its power source. Remove the power cord from the machine. Loosen the captive screws shown in picture 1.Pic...
Posted in: Epilog Zing

Orange arrow How do I replace the lens assembly on the 36EXT?

15684 views
  Replacing the Epilog Legend 36EXT Lens Assembly Although the standard 2" focal lens that comes with the EXT will work well for most projects, to achieve the optimum laser beam on special types of projects, we offer two optional focus lenses. The optional lenses on the Legend 36EXT are designed not...
Posted in: Replacing Optics

Orange arrow How do I replace the laser in my Zing Laser?

11516 views
  Machine Type: Epilog Zing 16 and 24 Lasers Tools Required: #1 Phillips screw driver Lower the table to the bottom of the machine. Turn off the machine. Disconnect the machine from its power source. Remove the four Phillips screws which secure the left hand side panel. There a...
Posted in: Epilog Zing

Orange arrow How do I replace the fans on my Epilog Mini or Helix System?

10993 views
  Fan Replacement on the Epilog Mini and Helix Systems Machine Type: Epilog Mini 18/24 and Helix Tools Needed: #2 Phillips head screwdriver, 6/32 Nut driver Flat head screwdriver or wire cutter Turn engraver off and unplug it from the wall. Face the back of the machine where the ex...

Page: 1 of 1