Support Center > Knowledge base> Tagged: x-axis
Tag: x-axis
7 Articles
Orange arrow How do I replace the x-axis rail on my Epilog Mini?

12396 views
  X-Axis Rail Assembly Replacement on the Epilog Mini Machine Type: Epilog Mini 18/24Tools Needed: Large Philips head screw driverSmall Philips head screw driverFlat head screw driver3/32 Allen wrenchTorx Screw Driver with 3/32 hex bitIntro: This procedure details steps to replacing the X-A...
Posted in: Epilog Mini
Tagged: x-axis, mini, rail


Orange arrow How do I replace the x-axis motor on my Epilog Mini?

10626 views
  X-Axis Motor Replacement on the Epilog Mini Machine Types: Epilog Mini 18/24 Tools Needed: #2 Phillips Head Screwdriver Turn off and unplug the laser engraver. You will need to remove the left and right sides of the engraver. To do this, you will need to remove the 6 Phillips head screws on e...
Posted in: Epilog Mini
Tagged: x-axis, motor, mini


Orange arrow How do I remove the X-Axis assembly and reinstall the new one in the Zing Laser?

13535 views
  X-Axis Assembly Removal and Installation for the Epilog Zing Machine Type: Epilog Zing 16 and 24 Tools Required: Phillips screw driver Disconnect the machine from its power source. Remove the power cord from the machine. Loosen the captive screws shown in picture 1.Pic...
Posted in: Epilog Zing

Orange arrow How do I replace the X-Axis encoder strip for my Epilog Mini or Helix?

11939 views
  X-Axis Encoder Strip Replacement for the Mini/Helix Machine Type: Epilog Mini 18/24, Helix Tools Needed: # 1 Phillips head screw driver Small Phillips head screw driver 3/32 Allen wrench Make sure power is turned off and power cord is unplugged from the wall outlet. Open up the...
Orange arrow How do I replace the X-Axis Read Head on my Mini?

11202 views
  X-Axis Encoder Read Head Replacement on the Mini/Helix Machine Type: Mini 18/24 Tools Required: Large #2 Phillips head screwdriver Small #3 Phillips head screwdriver 3/32 Allen Wrench Make sure the engraver is shut off. Open the plexi-glass window on the engraver. Pull the X-axis beam to t...
Posted in: Epilog Mini

Orange arrow How do I replace the x-axis belt on my Mini?

18861 views
  X-Axis Belt Replacement on the Mini Machine Type: Epilog Mini 18/24 Tools Needed: #1 and #2 Screwdriver Stapler Turn off the machine and unplug the power cord. Remove the left side panel from the engraver by removing the six screws that fix it to the body of the Mini or Helix. T...
Posted in: Epilog Mini
Tagged: replace, x-axis, mini, belt


Orange arrow How do I replace the I-beam on my Epilog Mini?

6247 views
  I-Beam Replacement on the Epilog Mini Machine Types: Epilog Mini 18/24 Tools needed: No. 2 Phillips head screwdriver No. 1 Flat head screwdriver Wire clipper Nylon tie Make sure the machine is turned off. Assuming you are facing the front of the machine, pull the right and left side pane...
Posted in: Epilog Mini
Tagged: x-axis, mini, i-beam



Page: 1 of 1