Aligning the CO2 Laser in the Fusion Edge
How do I align the CO2 laser in my Fusion Edge?
The instructions below show how to align the CO2 laser in the following models: Fusion Edge 12, 24 & 36, Fusion Pro 24 & 36.
Note: this procedure is for CO2 models only and is not intended for use on fiber and/or dual source models.
17000 - Fusion Edge CO2 Alignment.pdf
If further assistance is needed, please reach out to Epilog Tech Support by phone at 303-215-9171, or email at firstname.lastname@example.org.