Skip to main content
Tech Support: (+1) 303-215-9171
|
Sales: (+1) 303-277-1188
| made in usa

Setting Default Job Settings in the Epilog Software Suite

How can I set up default job settings in the Software Suite?

Instructions on how to set up default job settings in the Epilog Software Suite.

When a job is sent to the Epilog Software Suite, it is imported with default settings. These settings are then adjusted for a specific application or material. In some cases, a user may want to change the default settings to better fit their needs or to save time when setting up a job. The attached document shows how to change the default settings that appear when a job is sent to the Epilog Software Suite.

If further assistance is required, please contact Epilog Laser Technical Support by phone at 303-215-9171, or by email at tech@epiloglaser.com.