Backplane Install – Zing
Please find the attachment for an in-depth description.
Blurry Driver Screen On Windows 10
Please find the attachment for an in-depth description
Carriage Optics Install – Zing
Please find the attachment for an in-depth description.
Cleaning Your Optics
Remove Side Panel To begin the optics cleaning procedure, shut off the laser and remove the power cord from the machine. Remove the left side panel by removing the three screws on the side of the machine. Remove the screw on the back of the machine. Remove the left side (...)
CO2 Laser Alignment – Zing 24
Estimated time: 60–90 minutes • Skill: Advanced This guide outlines the procedure for aligning the laser beam inside the Epilog Zing 24 engraver. Following these steps will ensure the optics are properly aligned for consistent laser performance and engraving quality. SAFETY GLASSES REQUIRED: Always wear safety glasses or protective eyewear (...)
CO2 Laser Tickle Settings
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics by modifying the radio frequency (RF) signals sent to the laser tube. The role of the RF signal is to excite and energize the gas mixture within the CO2 laser (...)
Extended Cold Start Guide
Lasers that have been inactive for a period of time may not fire right away. There are settings in the machine to help warm the laser before use. Please start with the CO2 Laser Tickle Settings guide first. If the laser has been inactive for an extended period of time, (...)
Fixing Table Movement: Replacing the Z-Axis Motor
Preparation Start by lowering the table to the bottom of the machine by pressing focus then the down arrow button. Shut off the laser and remove the power cord from the machine. Inside the machine, move the x-axis assembly to the rear of the machine. Put on the anti-static strap. (...)
Full Guide: Replacing the Laser Assembly
Estimated time: 20–30 minutes • Skill: Intermediate This procedure will guide you through the process of removing and installing the laser assembly in your Epilog Zing 16 laser system. Following these steps ensures proper alignment, secure mounting, and optimal performance of your engraving system. Laser Removal Power down and disconnect (...)
Full Guide: Replacing the Laser Assembly
Laser Removal: Lower the table to the bottom of the machine. Turn off the machine. Disconnect the machine from its power source. Remove the four Phillips screws which secure the left-hand side panel. There are three on the side and one on the rear as shown in picture 1a and (...)
How to Replace the Home Switch (XY PCB) – Zing
This guide will walk you through the replacement of the X/Y Limit PCB on your Zing. The X/Y Limit PCB is located on the right side of your X-Axis rail underneath the right-side panel. Removal Unplug the engraver from its power source. Next, remove the Control Assembly by loosening the (...)
Intermittent Missing Letters from CorelDRAW Print Output
Guidance for resolving missing letters in Epilog Software Suite output when printing from CorelDRAW, following recent Microsoft-related rendering and font-handling changes. Issue Summary Customers may report intermittent letters missing from text-based graphics or tags when printing from CorelDRAW through the Epilog Software Suite. In some cases, letters may also shift (...)