X-Achsen-Riemenspannung – Fusion / Fusion M2
Einstellung der Riemenspannung auf der X-Achse bei den Fusion M2 Fusion und Fusion M2 .
Filter
Einbau der X-Achsen-Umlenkrolle – Fusion / Fusion M2
Eine ausführliche Beschreibung finden Sie im Anhang.
Einbau des Tischmotors – Fusion / Fusion M2
Eine ausführliche Beschreibung finden Sie im Anhang.
X-Achsen-Riemenmontage – Fusion / Fusion M2
This guide outlines the step-by-step process for replacing the X-axis belt on your laser machine. Before beginning, ensure the machine is powered off and properly prepared for service. Each section includes detailed instructions and corresponding images to help you complete the procedure safely and efficiently. Please follow all notes and (...)
Objektivinstallation – Fusion / Fusion M2
Eine ausführliche Beschreibung finden Sie im Anhang.
Unscharfer Treiberbildschirm unter Windows
Eine ausführliche Beschreibung finden Sie im Anhang.
Einbau eines Rotationsmotors – Fusion / Fusion M2
Eine ausführliche Beschreibung finden Sie im Anhang.
Ersatz für obere Tür – Fusion / Fusion M2
Eine ausführliche Beschreibung finden Sie im Anhang.
Ersatz von Fiber Laser
Remove Panels Shut off the laser and remove the power cord from the machine. Use a 5/32” hex key to remove the hex screws that secure the lower panel on the rear of the machine, then remove the panel. Remove the top access panel on the left side of the (...)
CO2 30 – 80 Watt
Remove Panel Shut off the laser and remove the power cord from the machine. Use a 5/32” hex key to remove the ten hex screws which secure the lower panel on the rear of the machine, then remove the panel. Remove Old Laser Tube Disconnect the black connector from the (...)
Steuerplatine
Remove Old Control Board Shut off the laser and remove the power cord from the machine. Remove any Ethernet and USB cables from the back of the machine. Put on the anti-static wrist strap. Always wear the anti-static strap when handling the control board to avoid damaging the unit through (...)
Optik austauschen
Remove Lens Assembly Remove the lens assembly by loosening the three thumb screws on its front face until they spin freely. They are captive screws and will not come out of the assembly. Slide the assembly out of its housing. Remove Old O-Ring and Lens With the lens assembly in (...)