Einbau der Transportoptik – Zing
Eine ausführliche Beschreibung finden Sie im Anhang.
Filter
X-Achsen-Riemenmontage – Zing
Eine ausführliche Beschreibung finden Sie im Anhang.
Fehlerbehebungsleitfaden
The attached document talks about the most common issues observed while operating the Zing engraver as well as their most common solutions. Please be sure that the engraver is powered OFF before performing any of the procedures outlined in this document. Y Axis Too Far Forward on Boot If the (...)
Unscharfer Treiberbildschirm unter Windows
Eine ausführliche Beschreibung finden Sie im Anhang.
Backplane-Installation – Zing
Eine ausführliche Beschreibung finden Sie im Anhang.
Objektivträgerrollen
Remove Lens Assembly Shut off the laser and remove the power cord from the machine. Move the X-Axis Assembly to the center of the machine and the lens carriage to the center of the table. Loosen the two screws which secure the lens carriage to the belt assembly. As you (...)
Y-Motor-Ersatz
Remove Rear Panel Loosen the two screws on the back of the machine and remove the back panel. Remove Old Y-Motor Using a 3mm hex key, loosen the four hex screws located on the drive couplers located on both sides of the Y-Motor. Slide the drive couplers away from the (...)
Ersatz der X-Achsen-Baugruppe
Remove Right Side Panel Shut off the laser and remove the power cord from the machine. Inside the machine, move the x-axis assembly to the rear of the machine. Put on the anti-static strap. Clip the strap on to any metal part of the machine. Always wear the anti-static strap (...)
Reparatur der X-Achsenbewegung: Austausch des X-Motors
Remove Right Side Panel Shut off the laser and remove the power cord from the machine. Inside the machine, move the x-axis assembly to the rear of the machine. Put on the anti-static strap. Clip the strap on to any metal part of the machine. Always wear the anti-static strap (...)
Ersatz der Stromversorgung
Option 1: Lower the Table If your machine has power, lower the table to the bottom of the machine by pressing the ‘Focus’ button, then holding the down arrow button. Shut off the laser and remove the power cord from the machine. Option 2: Remove the Table If your machine (...)
Kurzanleitung: Austausch der Steuerplatine
Record Settings If your machine will boot up, we’ll start by writing down some settings that will save you time later. Press the Go and Pointer button at the same time to access the Function Menu and cycle through the headings by pressing the Go button. Write down the Serial (...)
CO2 -Tickle-Einstellungen
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics by modifying the radio frequency (RF) signals sent to the laser tube. The role of the RF signal is to excite and energize the gas mixture within the CO2 laser (...)