Archives des services et réparations

Assistant de calibrage de l'autofocus

Estimated Time: 2–5 Minutes | Skill Level: Basic The Autofocus Calibration Wizard allows the laser system to automatically determine the correct autofocus height using a calibrated reference surface. This process ensures accurate and consistent autofocus performance across supported materials. Running the Autofocus Calibration Wizard Open the Settings Menu (...)

03/24/2026

Assistant de calibrage de la mise au point

Guide étape par étape pour utiliser l'assistant de calibrage de la mise au point, disponible dans la version 1.1.2.1 et les versions ultérieures du micrologiciel.

Estimated Time: 5–10 Minutes | Skill Level: Basic The Focus Calibration Wizard allows the laser system to automatically determine the optimal focal height for the installed lens. This process engraves a test pattern on anodized aluminum and identifies the focus position that produces the brightest mark. Running the (...)

03/16/2026

Pro 24, Pro 36

Calibrage manuel de la jauge de mise au point – Fusion Maker, Edge, Pro

Apprenez à calibrer la jauge de mise au point manuelle sur une machine Fusion Maker, Edge ou Pro.

This procedure outlines the steps required to calibrate the manual focus gauge after completing the Focus Calibration Wizard. Proper calibration ensures that the gauge accurately reflects the correct focal height determined using the Calibration Wizard. Note: The Calibration Wizard is available only on firmware version 1.1.2.1 or later. To update (...)

12/31/2025

Pro 24, Pro 36

Alignement laser (optique à grande ouverture) – Fusion Pro

Comment aligner le laser de mon Fusion Pro avec une optique à grande ouverture ?

To ensure your CO2 laser engraver delivers optimal performance and consistent cutting quality, proper beam alignment is essential. Over time, vibration, wear, or component replacement can cause the laser beam to deviate from its intended path. This can result in reduced cutting power, inconsistent engraving, or premature wear of optics. (...)

12/31/2025

Pro 24/36, Pro 32/48

Guide d'étalonnage de la caméra IRIS

Comment calibrer le système de caméra IRIS sur les modèles Maker, Edge, Pro et Ascent ?

Estimated Time: 20–40 Minutes • Skill Level: Intermediate Important: All focus calibration procedures must be completed before performing a camera calibration to ensure accurate results. Click the tabs below to switch between machine types. Each tab shows the camera calibration procedure specific to that machine. Overview & Requirements Fusion Edge (...)

04/15/2026

Guide rapide : Calibrage du joystick pour des mouvements précis

Le calibrage du joystick peut résoudre des problèmes tels que des mouvements retardés, un contrôle imprécis ou le déplacement spontané du chariot en mode jog.

Steps to Calibrate the Joystick Open the Settings Menu On the display panel, press the gear icon in the top-right corner to open the Settings menu. Image 1: Home screen with gear icon in top-right corner Access Advanced Settings Press and hold the word “Settings” on the screen until the (...)

03/16/2026