Safety Features and Regulatory Compliance

Epilog has incorporated specific safety features into the Model 19000 Laser System in order to meet the requirements of 21 CFR 1040 and the International Standard EN 60825-1. These safety features include:

A safety enclosure (cabinet), which fully encloses the engraving laser and its beam path in Class 2 mode.
Dual redundant interlock systems that turn off the engraving laser when the window is opened.
A visible emission indication when the Laser Diode Pointer (Red Dot Pointer) is operating. There is an LED indicator on the machine’s top touch screen panel.

21 CFR 1040 and EN 60825-1 require that certification, identification, and warning labels be placed on laser products. Reproductions of labels on the Epilog Model 19000 Laser System follow, with their locations specified:

1. Certification/Identification Plate:
This engraved plate is located on the right side of the machine’s cabinet.

2. Warning Logotype:
Indicates that invisible and visible laser danger is present if the cover is opened or removed.

3. Descriptive Label:
This label identifies the classification of the Model 19000 in accordance with 21 CFR 1040.10 and EN 60825-1.

4. Non-interlocked Protective Housing Safety Label:

5. Defeatably-interlocked Protective Housing Safety Labels:

6. Electrical Safety Label:
Potentially dangerous electrical exposure is present if the cover is removed.

7. Fuse Label:

8. Mechanical Safety Label:
Dangerous rotating moving parts are accessible if this cover is opened or removed.

9. Consult Manual Label:
There is additional information in the manual.

10. Aperture Safety Label:

11. Power Labels:
Indicates the correct input power of the main electrical connection.

12. Fire Hazard:
Indicates machine can ignite materials during operation. Warns operators to stay attentive, remove combustible debris, and follow fire-safety procedures.

Fusion Ascent FCC

Supplier’s Declaration of Conformity

47 CFR Paragraph 2.1077 Compliance Information

Laser Materials Processing System Model 19000
Epilog Laser Corporation
16371 Table Mountain Parkway
Golden, CO 80403
Telephone: (303) 277-1188

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Helpful Note:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This product contains a Certified transmitter module (wireless network interface), FCC ID: Z64-WL18DBMOD

Table des matières

Safety Features and Regulatory Compliance

Fusion Ascent FCC

Supplier’s Declaration of Conformity

Helpful Note: