Kalibratie van de camera boven je hoofd

Install Mat: Place calibration mat in the upper-left corner of the table. Ensure the green circle is in the corner.
Run: Close doors and press OK.
Follow the prompt and close the top door of the engraver.
Allow the process to run until completion. The camera at the laser head will take pictures of the mat to calibrate itself. This process takes several minutes.
Once the calibration has successfully finished, a dialog will appear. The “Reprojection error” will be listed and is used to determine the quality of the calibration. The lower the value, the better. A value of 0.6 or lower is desired. If the reprojection error is above 2.0, the user will see an error “Calibration unsuccessful. Error too high”.

Ga verder met je laseravontuur