STOP! Before using the Rotary Attachment for the first time, update your machine to the latest firmware. See Section 10: Upgrading Firmware for additional information.
Important: Always power off the laser system before installing or removing the Rotary Attachment. The Fusion Galvo G100 will not recognize the rotary until the system is rebooted, and installing the attachment while the machine is powered on may damage the electronics.
-
With the rotary connected and firmware updated, open the Settings Menu from the upper-right corner of the display.
Galvo Manual - images/0_rotary_update_galvo_settings.png -
In the Settings Menu, select the gear icon to open the Configuration Menu.
Galvo Manual - images/1_rotary_update_galvo_settings.png -
Select Rotary from the Configuration Menu.
Galvo Manual - images/2_rotary_update_galvo_advanced_settings.png -
Select Rotary Encoder.
Galvo Manual - images/3_rotary_settings.png -
Verify that the Rotary Encoder value is set to 38425. If necessary, change the value.
Galvo Manual - images/4_rotary_settings.png -
Press OK to save the setting.
Galvo Manual - images/5_rotary_settings.png - Your 3-Jaw Chuck Rotary Attachment is now ready to use.