Ga naar de hoofdinhoud

Service en reparatie

Serie: 17000

Filters

Getting Started (8)
Usage and Operation (100)
Service and Repair (56)
Handleiding (0)
Results: 56 items found
  • Bekijk:
Sorteren op
Relevantie

Filters

Getting Started (8)
Usage and Operation (100)
Service and Repair (56)
Handleiding (0)
Wizard voor het kalibreren van de focus

Wizard voor het kalibreren van de focus

Stapsgewijze handleiding voor het gebruik van de Focus Calibration Wizard, beschikbaar in firmwareversie 1.1.2.1 en hoger.

Estimated Time: 5–10 Minutes   |   Skill Level: Basic The Focus Calibration Wizard allows the laser system to automatically determine the optimal focal height for the installed lens. This process engraves a test pattern on anodized aluminum and identifies the focus position that produces the brightest mark. Running the (...)
Lees meer
Autofocus-schakelaar vervangen – Fusion Maker, Edge, Pro 24 & 36
Pro 24, Pro 36

Autofocus-schakelaar vervangen – Fusion Maker, Edge, Pro 24 & 36

Hoe vervang ik de autofocusknop in de Fusion Maker, Edge en Pro 24 en 36?

This procedure outlines the steps required to safely and effectively replace the Autofocus Switch on the Fusion Maker, Edge, and Pro, laser system. The Autofocus Switch is a critical component responsible for maintaining the proper focal distance during operation. This document provides detailed instructions to ensure proper removal, and installation (...)
Lees meer
Optiek schoonmaken – Fusion Maker, Edge en Pro

Optiek schoonmaken – Fusion Maker, Edge en Pro

In dit document wordt uitgelegd hoe je de optische onderdelen van de Fusion Maker, Edge en Pro op de juiste manier schoonmaakt.

Daily Maintenance Cleaning Remove the lens and carriage mirror. Safely detach both the lens and carriage mirror using the video guide below. Figure 1. Lens and carriage mirror removal process. Carriage Optics Removal Steps Disconnect the air tubing from the lens. Loosen the thumb screws on the carriage cover and (...)
Lees meer