Set the IP Address

Ethernet Setup

1. A screen will appear asking how you would like to connect your laser. Select “Ethernet”.

2. Select the text in the IP Address box and type in whichever IP Address you prefer to use. Most Epilog users will use the IP Address of 192.168.3.4 which is what we use in this manual. Press the Green arrow to complete the setup.

3. This will be the IP Address you use in the Job Manager when you set up your machine.

USB Cable Setup

1. A screen will appear asking how you would like to connect your laser. Select “USB”.

2. Under “IP Address” the IP Address will be 169.254.7.2. Press the Green arrow to complete the setup.

3. This will be the IP Address you use in the Job Manager when you set up your machine. 

Wireless Setup

Note: This procedure applies only to machines supplied outside the EU and EEA. See “Regional configurations” in Section 1.

1. A screen will appear asking how you would like to connect your laser. Select “Wireless”.

2. On the next screen, select your wireless network from the list and press the green next arrow. Select “WPA2 Personal” if you are connecting to a secured network. Select Open if you are connecting to an open network. Tap the box under “Security Key” and type in your password. Then press the green next arrow to connect.

3. Select “Obtain an IP Address Automatically” and click the green arrow to finish setup. Once connected, your screen will show a green check mark. Press the green next arrow.