X-Axis Belt Tension – Fusion / Fusion M2
X-axis belt tension adjustment in the Fusion and Fusion M2 engravers.
Filters
Interlock Install – Mini / Helix
Interlock sensor replacement instructions for the Mini and Helix engraver.
Table Belt Install – Mini / Helix
Please find the attachment for an in-depth description.
Y-Axis Slider Block Install – Mini / Helix
Y-Axis slider block replacement for the Mini and Helix engravers.
Y-Axis PCB Install – Mini / Helix
Please find the attachment for an in-depth description.
X-Axis Encoder Reader Install – Mini / Helix
This article provides step-by-step instructions for replacing the X-axis encoder read head in Epilog Laser engravers, specifically for the Mini 18×12, Mini 24×12, and Helix 24×18 models. The procedure outlined below will guide you through the necessary steps to successfully replace the read head, ensuring that the X-axis system functions (...)
X-Axis Belt Install – Zing
Please find the attachment for an in-depth description.
Carriage Optics Install – Zing
Please find the attachment for an in-depth description.
Top Door Replacement
Please find the attachment for an in-depth description.
Diagnostic LEDs – Fusion / Fusion M2
This document will describe how the diagnostic LEDs function, and their behavior during the boot up sequence. Locating the Diagnostic LEDs The diagnostic LEDs are on the Control Assembly panel in the back of the engraver. This panel also contains connections for Ethernet, USB and Air Assist. The LEDs are (...)
Laser Safety and Status Indicators – Fusion M2
The Fusion M2 status indicators are located on the top of the machine, to the right of the top cabinet door. Their markings, colors, and functions are as follows. Safety Interlock / Laser Status Indicators Label Description L Left-hand interlock status indicator (green LED). If the indicator is on (illuminated), (...)
X-Axis Belt Install – 36EXT
This procedure details steps to replace the belt that carries the laser head. These belts may get worn out and must be replaced for optimal performance from your machine. Always ensure proper safety precautions are taken when servicing hardware components. Procedure Steps Step 1 Remove side panels Remove both side (...)