Y-Axis Actuator Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the y-axis actuator in the Fusion pro 32 and 48.
Filters
SD Card and Coin Battery Replacement – Fusion Maker, Edge, Pro 24 & 36
This guide provides step-by-step instructions for replacing the SD card and coin battery on Fusion Maker, Edge, and Pro systems. Be sure to follow anti-static precautions and use the required tools for each step. SD Card Replacement (Fusion Maker & Edge) Control Module / SD Card Removal Turn off the (...)
X-Axis Idler Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the x-axis idler in the Fusion Pro 32 and 48.
How to Replace the CO₂ Laser Tube & RF Unit
Estimated time: 60–90 minutes • Skill: Intermediate This guide outlines the procedure for replacing CO₂ and 120-Watt laser tubes, as well as the RF unit, on Epilog laser systems. Following these steps ensures the components are removed, installed, and connected safely and correctly. For this procedure, you will need the (...)
Table Motor Replacement – Fusion Galvo
This document outlines the replacement of the z-axis motor in the Fusion Galvo.
Fiber Laser Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the fiber laser in the Fusion Pro 32 and 48.
Table Switch Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis board in the Fusion Pro 32 and 48.
Red Dot Diode Replacement – Fusion Galvo
This document outlines the replacement of the red dot diode assembly in the G100.
Vision System Repair: Replacing the Overhead Camera
Estimated time: 20–30 minutes • Skill: Intermediate This procedure guides you through removing and replacing the Overhead Camera on Fusion Edge and Fusion Pro engravers. Following these steps ensures the camera assembly is installed correctly, and the system is updated and calibrated for accurate camera-based alignment and job preview functionality. (...)
X-Axis Drive Board Replacement
Please find the attachment for an in-depth description.
Checking and Leveling the Table
Estimated time: 15-20 minutes • Skill: Beginner A perfectly level engraving table is essential for accurate focusing and consistent engraving results. This guide will walk you through checking and adjusting the table level on your Epilog Mini or Helix laser system. Checking Table Level Access the table. Power on the (...)
Fan Replacement on the Epilog Mini and Helix Systems
Machine Type: Epilog Mini 18/24 and Helix Tools Needed: #2 Phillips head screwdriver, 6/32 Nut driver Flat head screwdriver or wire cutter Turn engraver off and unplug it from the wall. Face the back of the machine where the exhaust is located. Remove the 8 screws holding the back panel (...)