Table Belt Install – Mini / Helix
Please find the attachment for an in-depth description.
Filters
Table Motor Install – Fusion / Fusion M2
Please find the attachment for an in-depth description.
Table Motor Install – FiberMark
Please find the attachment for an in-depth description.
Z-Motor / Table Motor Replacement
Remove Bottom Right Panel Shut off the laser and remove the power cord from the machine. Remove the bottom access panel on the right side of the machine by using a 5/32” hex key to turn the black panel locks ¾ of the way counter-clockwise. Mark Tensioning Position Begin by (...)
Z-Motor / Table Motor Replacement
Adjust Table Position Start by turning on the machine and then raise the table all the way to the top. Shut off the laser and remove the power cord from the machine. To manually adjust your laser machine’s vertical table position, pull on the belt located underneath the table to (...)
Fixing Table Movement: Replacing the Z-Axis Motor
Preparation Start by lowering the table to the bottom of the machine by pressing focus then the down arrow button. Shut off the laser and remove the power cord from the machine. Inside the machine, move the x-axis assembly to the rear of the machine. Put on the anti-static strap. (...)
Checking and Leveling the Table
Estimated time: 15-20 minutes • Skill: Beginner A perfectly level engraving table is essential for accurate focusing and consistent engraving results. This guide will walk you through checking and adjusting the table level on your Epilog Mini or Helix laser system. Checking Table Level Access the table. Power on the (...)
Setting Manual Focus and Auto Focus on the Mini/Helix
Proper focus calibration is essential for achieving consistent and high-quality results when using laser engraving machines. This step-by-step guide outlines the process for adjusting the autofocus on Epilog Mini 18/24 and Helix machines using a 4×4 piece of anodized aluminum. By following these instructions carefully, users can ensure that their (...)
- 1
- 2