Emergency Stop Button
On the top of all Fusion Ascent models, you will see a large, red Emergency Stop Button. If there is...
Fusion Ascent
Filters
Vector Cutting Table
On all Fusion Ascent models, the Vector Cutting Table is used for both standard engraving jobs, as well as vector...
Exhaust Plenum
The Fusion Ascent incorporates an Exhaust Plenum. The exhaust fan moves air from the front towards the rear of your...
Status Light
The Ascent has two emission indicators: one located in the Key Switch and E-Stop cluster above the LC1000 main controller...
Reduce Fire Risk with a Clean Laser
Cleaning your machine is an excellent way to prevent fire with the laser. A buildup of cutting and engraving residue...
Fusion Ascent Suggested Material Settings (CO2)
Material DPI / Freq. 30 watt 40 watt 60 watt 80 watt Acrylic Photo Engraving 300 DPI 100s 75p 100s...
Fusion Ascent Suggested Material Settings (Fiber)
Material DPI / Freq. 30 watt 60 watt Aluminum (Anodized) Etching/Marking 800 DPI Speed: 30% Power: 100% Frequency: 1% Focus:...
Cleaning the Optics on the Fusion Ascent
Cleaning the Lens The focus lens is contained within the lens assembly. Remove the cover of the lens assembly by...
Cleaning the Exhaust Plenum
Make sure the exhaust blower you are using receives proper service. Periodically clean the exhaust blower and duct system to...
Laser Tube
The laser tube used in your system does have a maximum service life, and there is very little maintenance that...
Fusion Ascent 12/24/36 Technical Specifications
Fusion Ascent 12 Fusion Ascent 24 Fusion Ascent 36 Specification CO₂ Fiber CO₂ Fiber CO₂ Maximum Engraving Area 24” x...
Compatibility
Your Epilog Laser has been designed as an “open architecture” product that can be run from almost any Windows based...
About The CO2 Laser Source
Your Epilog CO2 laser system uses the latest in laser technology to provide a powerful tool that is simple and...
Federal Communications Commission (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to...
Contacting Technical Support
The technical support department at Epilog is available to assist with solving problems you may encounter using your Epilog. Please...
Frequently Asked Questions
Engraver Will Not Vector Verify that the print driver is set to Vector or Combined mode. Verify that the lines...
Join Epilog Laser’s Online Community
Find out the latest Epilog news, keep in touch with our customers, and stay connected through our social media channels!...
Warranty Statement for the Fusion Ascent Laser System
Epilog Corporation warrants to the original purchaser of Epilog Fusion Model 19000 that the product will be free from defects...