Service and Repair Archives

Flashing SD Cards

Learn how to flash an SD card for Epilog Laser systems using Balena Etcher.

This guide outlines the steps for flashing an SD card for your laser system. A technician must provide the required disc image file to complete this process. Do not proceed without first obtaining the correct file specific to your machine. Flashing SD Cards SD Card Removal Remove the control board (...)

06/19/2025

Pro 24, Pro 36

How to Replace the X-Axis Motor Driver: Step-by-Step Guide

Learn how to replace the TE0104 X-Axis Drive Board on 17000 Edge and Pro machines. This fix can potentially resolve various X-Axis motion issues and help restore smooth operation.

This guide will walk you through the process of removing, installing, and programming the X-Axis Drive Board for Fusion Edge and Pro 24 / 36 models. Proper precautions, including the use of an anti-static strap, are essential to ensure the safe handling of electronic components. Drive Board Replacement Procedure Models: (...)

11/11/2025

Pro 24, Pro 36

Control Module Replacement – Fusion Edge, Maker, Pro

The control module is a crucial component of your Fusion Maker, Fusion Edge, or Fusion Pro engraver, enabling seamless operation and precise control. This guide provides step-by-step instructions for safely removing and installing a new control module to ensure optimal performance. Following these procedures will help you maintain your engraver’s (...)

04/04/2025

Replacing the Control Panel

Replace your machine's display panel.

Replacing the Control Panel We’re going to walk you through replacing the control panel on the Epilog Fusion Edge laser system. Turn off and unplug the machine. Remove Panel Using a 5/32″ Hex Key, remove the 8 screws that secure the right-hand side access panel and set them to the (...)

09/24/2024

Pro 24, Pro 36

X-Axis PCB Replacement

How do I replace the x-axis PCB in the Fusion Maker, Edge, and Pro 24 and 36?

This document outlines the replacement of the x-axis PCB in the Fusion Maker, Edge, and Pro 24 and 36.

09/24/2024

Pro 24, Pro 36

SD Card and Coin Battery Replacement – Fusion Maker, Edge, Pro 24 & 36

How do I replace the SD card and coin battery in the Fusion Maker, Edge, and Pro 24 and 36?

This guide provides step-by-step instructions for replacing the SD card and coin battery on Fusion Maker, Edge, and Pro systems. Be sure to follow anti-static precautions and use the required tools for each step. SD Card Replacement (Fusion Maker & Edge) Control Module / SD Card Removal Turn off the (...)

06/11/2025

Control / Circuit Boards

Filters

Filters

Flashing SD Cards

How to Replace the X-Axis Motor Driver: Step-by-Step Guide

Control Module Replacement – Fusion Edge, Maker, Pro

Replacing the Control Panel

X-Axis PCB Replacement

SD Card and Coin Battery Replacement – Fusion Maker, Edge, Pro 24 & 36