Cleaning Your Optics
Remove Side Panel To begin the optics cleaning procedure, shut off the laser and remove the power cord from the...
Zing
Filters
Laser Alignment – Zing
Mark the Laser Alignment Target To begin the laser alignment procedure, in your graphics software, set your page size equal...
Table Level Procedure
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
X-Axis Belt Tension
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
CO2 Laser Alignment – Zing 24
Estimated time: 60–90 minutes • Skill: Advanced This guide outlines the procedure for aligning the laser beam inside the Epilog...
Full Guide: Replacing the Laser Assembly
Estimated time: 20–30 minutes • Skill: Intermediate This procedure will guide you through the process of removing and installing the...
X-Axis Carriage Install – Zing
Lens carriage removal procedure in the Zing engraver. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
Y-Axis Belt Replacement – Zing
Replacing the Y-axis belt on your Epilog Zing laser machine is a straightforward process that ensures optimal performance and precision...
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out...
Extended Cold Start Guide
Lasers that have been inactive for a period of time may not fire right away. There are settings in the...
CO2 Laser Tickle Settings
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics...
Quick Guide: Replacing the Control Board
Record Settings If your machine will boot up, we’ll start by writing down some settings that will save you time...
Power Supply Replacement
Option 1: Lower the Table If your machine has power, lower the table to the bottom of the machine by...
Repairing X-Axis Motion: Replacing the X-Motor
Remove Right Side Panel Shut off the laser and remove the power cord from the machine. Inside the machine, move...
X-Axis Assembly Replacement
Remove Right Side Panel Shut off the laser and remove the power cord from the machine. Inside the machine, move...
Y-Motor Replacement
Remove Rear Panel Loosen the two screws on the back of the machine and remove the back panel. Remove Old...
Fixing Table Movement: Replacing the Z-Axis Motor
Preparation Start by lowering the table to the bottom of the machine by pressing focus then the down arrow button....
Lens Carriage Rollers
Remove Lens Assembly Shut off the laser and remove the power cord from the machine. Move the X-Axis Assembly to...
- 1
- 2