Skip to main content

16000 - Fusion Pro 32 & 48 - Leveling the Table

How do I level the table in the Fusion Pro 32 and 48?

Date updated: 09/26/2024
Machine Series: Fusion Maker, Fusion Edge, Fusion Pro
Categories: System Maintenance
Key Words: Fusion Pro | Table Level | Low Power | Service Procedures
Table leveling instructions for the Fusion Pro 32 and 48.

This document outlines the table leveling procedure for the Fusion Pro 32 and 48.

Table level should be checked periodically to ensure that all areas of the table are the same distance from the focusing lens. If all areas of the table are not the same distance from the focusing lens, loss of laser power and inconsistent engraving and cutting marks can occur.

Complete this procedure if any of the following behaviors are observed:

  • Laser power appears weak in certain areas of the table.
  • The engraver is unable to cut through materials at or around the recommended settings in certain areas of the table.
  • If the engraver has been moved to a new location.

If further assistance is required, please visit www.epiloglaser.com/support to contact Epilog Laser Technical Support.

Resources