17000 - Fusion Maker, Edge, Pro 24 & 36 - Z-Axis Switch Board Replacement
How do I replace the z-axis switch board in the Fusion Maker, Edge, and Pro 24 and 36?
Z-axis switch board replacement instructions for the Fusion Maker, Edge, and Pro 24 and 36.
This document outlines the replacement of the CO2 laser tube in the Fusion Maker, Edge, and Pro 24 and 36.
After replacing the CO2 laser tube, complete the laser alignment and focus calibration procedures.
If further assistance is required, please visit www.epiloglaser.com/support to contact Epilog Laser Technical Support.