17000 - Fusion Maker, Edge, Pro 24 & 36 - Leveling the Table

This document outlines the table leveling procedure for the Fusion Maker, Edge, and Pro 24 and 36.

Table level should be checked periodically to ensure that all areas of the table are the same distance from the focusing lens. If all areas of the table are not the same distance from the focusing lens, loss of laser power and inconsistent engraving and cutting marks can occur.

Complete this procedure if any of the following behaviors are observed:

• Laser power appears weak in certain areas of the table.
• The engraver is unable to cut through materials at or around the recommended settings in certain areas of the table.
• If the engraver has been moved to a new location.