Cleaning Your Optics
Move X-Axis Assembly To start the optics cleaning procedure, with the machine powered on, use the control panel to scroll...
Fusion / Fusion M2
Filters
Laser Alignment – Fusion / Fusion M2
Alignment Target Place the alignment target in the round opening on the side of the lens assembly. Then cover the...
Bearing Rails
To begin the procedure of cleaning and greasing the bearing rails, shut off the laser and remove the power cord...
How to align the laser for the Fusion FiberMark
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
Focus Calibrations
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
Table level Procedure
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out...
Extended Cold Start Guide
Lasers that have been inactive for a period of time may not fire right away. There are settings in the...
CO2 Laser Tickle Settings
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics...
Replacing the Control Panel
Remove Panel Remove the top access panel on the right side of the machine by using a 5/32” hex key...
Power Supply Replacement
Remove Panel Remove the lower access panel on the right side of the machine by using a 5/32” hex key...
RF Power Supply Replacement
Remove Panel Shut off the laser and remove the power cord from the machine. Remove the bottom access panel on...
Safety Module
Remove Panel Shut off the laser and remove the power cord from the machine. Remove the top access panel on...
X-Motor Replacement
Remove Side Panels With the machine powered on, use the control panel to scroll down to ‘Jog.’ Then use the...
X-Axis Assembly Replacement
Remove Panels With the machine powered on, use the control panel to scroll down to ‘Jog.’ Then use the joystick...
Restore X-Axis Homing: Replacing the Home (Limit) Sensors
Remove Panels We’ll start by replacing the left sensor, then move on to the right sensor. Shut off the laser...
X-Axis Tensioning Belt
Remove Panel Shut off the laser and remove the power cord from the machine. Remove the top access panel on...
Y-Axis Assembly
Remove Panels Shut off the laser and remove the power cord from the machine. We’ll begin by replacing the y-axis...