X-Axis Belt Tension – Fusion / Fusion M2
X-axis belt tension adjustment in the Fusion and Fusion M2 engravers.
Filters
X-Axis Idler Install – Fusion / Fusion M2
Please find the attachment for an in-depth description.
Table Motor Install – Fusion / Fusion M2
Please find the attachment for an in-depth description.
X-Axis Belt Install – Fusion / Fusion M2
This guide outlines the step-by-step process for replacing the X-axis belt on your laser machine. Before beginning, ensure the machine is powered off and properly prepared for service. Each section includes detailed instructions and corresponding images to help you complete the procedure safely and efficiently. Please follow all notes and (...)
Lens Install – Fusion / Fusion M2
Please find the attachment for an in-depth description.
Blurry Driver Screen On Windows 10
Please find the attachment for an in-depth description
Rotary Motor Install – Fusion / Fusion M2
Please find the attachment for an in-depth description.
Top Door Replacement – Fusion / Fusion M2
Please find the attachment for an in-depth description.
Fiber Laser Tube Replacement
Remove Panels Shut off the laser and remove the power cord from the machine. Use a 5/32” hex key to remove the hex screws that secure the lower panel on the rear of the machine, then remove the panel. Remove the top access panel on the left side of the (...)
CO2 Laser Tube Replacement 30 – 80 Watt
Remove Panel Shut off the laser and remove the power cord from the machine. Use a 5/32” hex key to remove the ten hex screws which secure the lower panel on the rear of the machine, then remove the panel. Remove Old Laser Tube Disconnect the black connector from the (...)
Controller Board
Remove Old Control Board Shut off the laser and remove the power cord from the machine. Remove any Ethernet and USB cables from the back of the machine. Put on the anti-static wrist strap. Always wear the anti-static strap when handling the control board to avoid damaging the unit through (...)
Replacing Optics
Remove Lens Assembly Remove the lens assembly by loosening the three thumb screws on its front face until they spin freely. They are captive screws and will not come out of the assembly. Slide the assembly out of its housing. Remove Old O-Ring and Lens With the lens assembly in (...)