IRIS Camera Calibration Guide
Estimated Time: 20–40 Minutes • Skill Level: Intermediate Important: All focus calibration procedures must be completed before performing a camera...
Fusion Maker
Filters
Quick Guide: Calibrating the Joystick for Accurate Movement
Steps to Calibrate the Joystick Open the Settings Menu On the display panel, press the gear icon in the top-right...
When to Calibrate the IRIS Camera System
Applies to: Fusion Maker • Fusion Edge • Fusion Pro • G100 All Fusion Maker, Edge, Pro, and G100 engravers...
Cleaning Your Optics
Cleaning the Focusing Lens Optics The mirrors in the periscope housing are enclosed, and will likely require cleaning less often...
Laser Alignment – Maker / Edge / Pro
Turn On To begin the laser alignment procedure, power on the laser. For the following procedures, the table will be...
Focus Calibrations – Fusion Maker, Edge, and Pro
Please find the attachment for an in-depth description. Was this helpful? Yes No Submit Cancel Thanks for your feedback!...
Fiber Alignment – Fusion Pro 32 & 48
This guide provides step-by-step instructions for performing precise laser alignment on the Fusion Pro CO2 and Fiber laser systems. Proper...
Touchpad Calibration – Fusion Maker, Edge, and Pro 24 and 36
Estimated time: 5 minutes • Skill: Basic Touchscreen calibration ensures accurate touch response when selecting options and settings on the...
Leveling the Table
This document outlines the table leveling procedure for the Fusion Maker, Edge, and Pro 24 and 36. Table level should...
Adjusting the Home and Park Positions
This document outlines the home and park position adjustment procedures for the Fusion Maker, Fusion Edge, and Fusion Pro. Was...
X-Axis Belt Tensioning Guide
Identifying X-Axis Rail Version Before you begin, determine which version of the X-Axis rail is installed in your machine. Check...
Edge Stand Assembly
The Fusion Edge Stand is an essential accessory designed to support your laser system with stability and ease of mobility....
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out...
Extended Cold Start Guide
Lasers that have been inactive for a period of time may not fire right away. There are settings in the...
CO2 Laser Tickle Settings
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics...
CO2 Laser Replacement Checklist / No Output
These items should be checked before replacing a CO2 laser tube with no output. If the laser has been inactive...
Maker X-Axis Motor Install
This document outlines the step-by-step procedure for removing and replacing the X-Axis motor in the Epilog Maker laser system. Proper...
Replacing the Laser Tube
Remove Panels Shut off the laser and remove the power cord from the machine. For this procedure you will need...