Linear Guide (IKO) Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the linear guide in the Fusion Pro 32 and 48.
Filters
Vision System Repair: Replacing the Overhead Camera
Estimated time: 30–45 minutes • Skill: Intermediate This guide outlines the procedure for replacing the overhead camera on the Epilog Fusion Pro 32 and 48 laser systems. Following these steps will ensure the camera is removed, installed, and updated correctly. For this procedure, you will need the required part: CS0834 (...)
X-Axis Idler Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the x-axis idler in the Fusion Maker, Edge, and Pro 24 and 36.
Fusion Maker, Edge, Pro 24 & 36 – Linear Guide (Rev 1 IKO) Replacement
This document provides concise, step‑by‑step instructions for removing and installing the X‑Axis linear guide (IKO rail) on Fusion Edge, Maker, and Pro 24/36 engravers. Read the entire procedure before beginning, observe all safety precautions (power off and disconnect), and have the required hand tools ready. Follow each step in order (...)
X-Axis Reducer Drive Replacement – Fusion Edge, Pro 24 & 36
This document outlines the replacement of the x-axis reducer in the Fusion Edge and Pro 24 and 36.
Table Belt Replacement
This document outlines the replacement of the z-axis belt in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis PCB Replacement
This document outlines the replacement of the x-axis PCB in the Fusion Maker, Edge, and Pro 24 and 36.
Y-Axis Home Switch Replacement
This document outlines the replacement of the y-axis home switch in the Fusion Pro 32 and 48.
Fiber Laser Replacement
This document outlines the replacement of the fiber laser in the Fusion Maker, Edge, and Pro 24 and 36. After replacing the fiber laser, complete the laser alignment and focus calibration procedures.
Backplane Board Replacement
This document provides step-by-step instructions for the removal and installation of the backplane board for Fusion Pro 24 & 36 engravers. It includes all the necessary parts, tools, and materials required for the process, as well as detailed guidance on disconnecting electrical components, handling the board with care, and reassembling (...)
Table Lead Screw Replacement
This document outlines the replacement of the lead screw in the Fusion Maker, Edge, and Pro 24 and 36.
Y-Axis Actuator Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the y-axis actuator in the Fusion pro 32 and 48.