Y-Axis Belt Install – Mini / Helix / FiberMark
This procedure details steps to replacing the Y-belts. The Y-belt controls the movement of the I-beam from the front and...
Mini / Helix
Filters
Restore Accuracy: Replacing the X-Axis Encoder Strip
Estimated time: 20–30 minutes • Skill: Basic This guide explains how to replace the encoder strip and reader assembly on...
Checking and Leveling the Table
Estimated time: 15-20 minutes • Skill: Beginner A perfectly level engraving table is essential for accurate focusing and consistent engraving...
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out...
Squaring the Ruler Guides
Machine Types: Epilog Mini 18/24, Helix If your rulers have been moved accidentally or on purpose and you would like...
Setting Manual Focus and Auto Focus on the Mini/Helix
Proper focus calibration is essential for achieving consistent and high-quality results when using laser engraving machines. This step-by-step guide outlines...
Y-Axis Flex Cable Install – Mini / Helix
This document provides detailed instructions for the removal and installation of the Y-Axis Flex Cable in the Epilog Mini/Helix and...
Extended Cold Start Guide
Lasers that have been inactive for a period of time may not fire right away. There are settings in the...
Optics Replacement – Mini/Helix
This guide provides step-by-step instructions for replacing the carriage, steering, and periscope optics in your laser system. Follow the outlined...
CO2 Laser Tickle Settings
Introduced in the Epilog Mini and Helix engravers, laser tickle settings allow the user to customize certain CO2 laser characteristics...
Autofocus Plunger Install
Estimated time: 15 minutes • Skill: Beginner This procedure walks you through replacing the Auto Focus Plunger on your laser...
Replacing the Display / Keypad
Remove Side Panels Remove the left side panel by loosening the four screws on its main face, as well as...
Fix a Power Issue: Replacing the Power Supply
Remove Old Power Supply Shut off the laser and remove the power cord from the machine. Loosen the 8 screws...
Fix a Power Issue: Replacing the Dual Power Supply
Remove Back Panel Shut off the laser and remove the power cord from the machine. Loosen the 8 screws on...
X-Motor Replacement
Remove Side Panels Shut off the laser and remove the power cord from the machine. Remove the left side panel...
X-Axis Assembly Replacement
Remove Side Panels Shut off the laser and remove the power cord from the machine. Remove the left side panel...
Y-Motor Replacement
Remove Right Panel Remove the right side panel by removing the 6 screws, 4 located on the side of the...
Z-Motor / Table Motor Replacement
Adjust Table Position Start by turning on the machine and then raise the table all the way to the top....