Service and Repair Archives

How to Align the FiberMark Laser for Accurate, High-Quality Engraving

Proper alignment is essential for achieving optimal engraving quality and ensuring maximum laser power output.

Estimated time: 20–30 minutes • Skill: Intermediate This document provides a step-by-step guide for aligning the FiberMark Laser Engraver to ensure optimal performance and accuracy. It outlines the necessary safety precautions and detailed alignment procedures to help users properly adjust the laser system. To complete this procedure, you will need (...)

12/31/2025

Manual Focus Gauge Calibration – FiberMark

How do I set the manual focus gauge on the FiberMark?

The attachment outlines the manual focus gauge calibration procedure for the FiberMark 24×12 engraver.

12/31/2025

CO2 Laser Alignment – Zing 24

How do I align the CO2 laser in my Zing 24?

Estimated time: 60–90 minutes • Skill: Advanced This guide outlines the procedure for aligning the laser beam inside the Epilog Zing 24 engraver. Following these steps will ensure the optics are properly aligned for consistent laser performance and engraving quality. SAFETY GLASSES REQUIRED: Always wear safety glasses or protective eyewear (...)

12/31/2025

How to align the laser for the Fusion FiberMark

How do I align the laser for the Fusion FiberMark?

Please find the attachment for an in-depth description.

12/31/2025

Focus Calibrations

How do I calibrate the Fusion M2/32/40 focus?

Please find the attachment for an in-depth description.

12/31/2025

Table level Procedure

How do I adjust the Fusion table level?

Please find the attachment for an in-depth description.

12/31/2025

MT

Laser Alignment – Mini / Helix MT

How do I align the Mini/Helix MT laser?

Proper laser alignment is essential to maintain the precision and performance of your Epilog Mini or Helix laser system. Over time, factors such as power inconsistencies, fading in specific areas of the engraving table, or component replacement—like the laser tube or mirrors—can lead to misalignment. This guide provides a detailed, (...)

12/31/2025

Table Level Procedure

How do I check and adjust the Zing table level?

Please find the attachment for an in-depth description.

12/31/2025

X-Axis Belt Tension

How do I tension the Zing X-axis belt?

Please find the attachment for an in-depth description.

12/31/2025

Pro 24/36, Pro 32/48

IRIS Camera Calibration Guide

How do I calibrate the IRIS camera system in the Maker, Edge, Pro, and Ascent?

Estimated Time: 20–40 Minutes • Skill Level: Intermediate Important: All focus calibration procedures must be completed before performing a camera calibration to ensure accurate results. Click the tabs below to switch between machine types. Each tab shows the camera calibration procedure specific to that machine. Overview & Requirements Fusion Edge (...)

04/15/2026

When to Calibrate the IRIS Camera System

When do I need to calibrate the IRIS camera system?

Applies to: Fusion Maker • Fusion Edge • Fusion Pro • G100 All Fusion Maker, Edge, Pro, and G100 engravers are equipped with the IRIS™ camera system, which overlays your artwork onto the engraving table and material within the Epilog Dashboard software. The accuracy of this system depends on proper (...)

12/31/2025

Calibrations

Filters

Filters

How to Align the FiberMark Laser for Accurate, High-Quality Engraving

Manual Focus Gauge Calibration – FiberMark

CO2 Laser Alignment – Zing 24

How to align the laser for the Fusion FiberMark

Focus Calibrations

Table level Procedure

Laser Alignment – Mini / Helix MT

Table Level Procedure

X-Axis Belt Tension

IRIS Camera Calibration Guide

When to Calibrate the IRIS Camera System