In this video, we will walk you through replacing the Power Supply on the Fusion Pro.
Before we begin, make sure to power off and unplug your machine.
Remove Old Power Supply
Now move to the rear of the machine.
Using the 5/32″ Allen Wrench, remove the screws securing the upper rear panel to access the Power Supply.
Locate the Power Supply under the access panel.
Now carefully disconnect all of the wires plugged into the back of the power supply by pressing down on the latch that connects each wire to the power supply.
The Power Supply is mounted to the machine by four 5/32″ Allen screws. There are two in the front, and two in the rear of the assembly. The two screws in the rear are captive screws that only need to be loosened. The two screws in the front are removable. Remove them using the 5/23 Allen Wrench.
Once the four screws have been removed, pull the power supply straight out of the back of the machine.
Install New Power Supply
Now it’s time to install the replacement power supply.
Place the power supply in the machine so that the rear captive screws line up with the mounting brackets on the power supply.
Tighten the two rear screws using the 5/32″ allen wrench, followed by replacing the two screws in the front, making sure the power supply is secure.
Now reconnect each of the wires back into the power supply.
Replace the upper rear panel on the machine by tightening all of the screws that secure it.
Following the replacement, the machine will need to update its peripherals.
Turn On Plug in the machine and power it on.
Once the machine has booted up, select the settings menu in the upper right corner of the screen.
Then press “Program” on the Settings Menu.
Under the list of peripherals, deselect everything except “Power Supply”, then press “Update”.
Once the update is complete, the screen will prompt you to Power Cycle the machine.
Turn the machine off and back on again. Graphical user interface
This completes replacing the power supply on the Fusion Pro.
