Table Lead Screw Replacement
This document outlines the replacement of the lead screw in the Fusion Maker, Edge, and Pro 24 and 36.
Backplane Board Replacement
This document provides step-by-step instructions for the removal and installation of the backplane board for Fusion Pro 24 & 36 engravers. It includes all the necessary parts, tools, and materials required for the process, as well as detailed guidance on disconnecting electrical components, handling the board with care, and reassembling (...)
Fiber Laser Replacement
This document outlines the replacement of the fiber laser in the Fusion Maker, Edge, and Pro 24 and 36. After replacing the fiber laser, complete the laser alignment and focus calibration procedures.
Control Module Replacement
This guide provides step-by-step instructions for replacing the control board in the G100 system. Always wear an anti-static strap and disconnect power before beginning any maintenance procedure. Control Board Removal Turn off the engraver. Disconnect the power cable. Locate the door handles. Open the door. Loosen and remove screws. Loosen, (...)
Y-Axis Home Switch Replacement
This document outlines the replacement of the y-axis home switch in the Fusion Pro 32 and 48.
Encoder Reader Installation
This procedure outlines the steps necessary to replace the X-axis encoder reader on the Legend EXT machine. The X-axis encoder reader is a crucial component for accurate movement tracking of the lens carriage assembly. Over time, this part may need maintenance or replacement to ensure continued precision and smooth operation (...)
X-Axis PCB Replacement
This document outlines the replacement of the x-axis PCB in the Fusion Maker, Edge, and Pro 24 and 36.
Table Belt Replacement
This document outlines the replacement of the z-axis belt in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis Reducer Drive Replacement – Fusion Edge, Pro 24 & 36
This document outlines the replacement of the x-axis reducer in the Fusion Edge and Pro 24 and 36.
Encoder Strip Install
The attached document will guide you through replacing the encoder strip on a 36EXT.
Y-Axis Reducer Drive Belt Replacement -Fusion / Fusion M2
The attached PDF contains the Y-Axis reducer drive belt installation instructions.
Fusion Maker, Edge, Pro 24 & 36 – Linear Guide (Rev 1 IKO) Replacement
This document provides concise, step‑by‑step instructions for removing and installing the X‑Axis linear guide (IKO rail) on Fusion Edge, Maker, and Pro 24/36 engravers. Read the entire procedure before beginning, observe all safety precautions (power off and disconnect), and have the required hand tools ready. Follow each step in order (...)