A loss of laser power on the Mini or Helix is usually caused by dirty or damaged optics, poor laser beam alignment, or a focus or table level problem. Work through the checks below in order.
Parts Required
- None
Tools Required
- Safety Glasses
- Phillips Screwdriver
- Allen Wrench (lens carriage screws)
- Masking Tape
- Alignment Target
1. Check the Optics
Inspect the optics for any damage: burn marks, pock marks, scratches, cracks, flaking coating or discoloration of any kind.
2. Check the Focus
Make sure the manual focus gauge and autofocus are set correctly. An out-of-focus beam engraves and cuts with less power.
3. Check the Table Level
If power is weak in only some areas of the table, the table may not be level, so the focus changes across the work area.
4. Check the Laser Alignment
If the optics, focus and table level are all good, check the laser beam alignment. Use the procedure for your engraver:
- Laser Alignment – Mini / Helix – MT (built 2004–2009, 8000 model)
- Laser Alignment – Mini / Helix
Safety First: Turn off and unplug the engraver before removing the lens carriage or any panels. Wear safety glasses whenever the laser is fired with panels removed.