This guide covers replacing the red dot diode assembly on the Fusion Galvo G100.
Parts Required
- GC0260 – Assy, Diode, Focus, F163 (4×4 Field)
- GC0265 – Assy, Diode, Focus, F254 (6×6 Field)
Tools Required
- T30 Torx Driver
- 7/64″ Allen Wrench
Safety First: Ensure the engraver is completely powered off and the power cord is disconnected before removing any panels or touching internal electronics.
Red Dot Diode Removal
Remove Top Panel Screws
Loosen and remove the screws around the edge of the top panel (highlighted in red).
Disconnect Diode Harness
Follow the red dot diode harness to its connector and disconnect it.
Loosen Holder Screws
Loosen the two screws on the diode holder (highlighted in red), but do not remove them.
Red Dot Diode Installation
Install the New Diode
Slide the new diode into the holder. Use GC0260 for the F163 (4″ x 4″) lens or GC0265 for the F254 (6″ x 6″) lens.
Complete the Calibrations
After installing a new red dot diode, complete the focus and camera calibrations. See Focus and Camera Calibrations – Fusion Galvo.