Skip to main content

Calibrations

16000-17000

Filters

Getting Started (11)
Usage and Operation (107)
Service and Repair (118)
Results: 16 items found
  • View:
Order by
Date (Newest First)

Filters

Getting Started (11)
Usage and Operation (107)
Service and Repair (118)
Manual Focus Gauge Calibration – Fusion Maker, Edge, Pro
Pro 24, Pro 36

Manual Focus Gauge Calibration – Fusion Maker, Edge, Pro

Learn how to calibrate the manual focus gauge on a Fusion Maker, Edge, or Pro machine.

This procedure outlines the steps required to calibrate the manual focus gauge after completing the Focus Calibration Wizard. Proper calibration ensures that the gauge accurately reflects the correct focal height determined using the Calibration Wizard. Note: The Calibration Wizard is available only on firmware version 1.1.2.1 or later. To update (...)
Read More
Laser Alignment (Large Aperture Optics) – Fusion Pro
Pro 24, Pro 36

Laser Alignment (Large Aperture Optics) – Fusion Pro

How do I align the laser on my Fusion Pro with large aperture optics.

To ensure your CO2 laser engraver delivers optimal performance and consistent cutting quality, proper beam alignment is essential. Over time, vibration, wear, or component replacement can cause the laser beam to deviate from its intended path. This can result in reduced cutting power, inconsistent engraving, or premature wear of optics. (...)
Read More
IRIS Camera Calibration Guide
Pro 24/36, Pro 32/48

IRIS Camera Calibration Guide

How do I calibrate the IRIS camera system in the Maker, Edge, Pro, and Ascent?

Estimated Time: 20–40 Minutes • Skill Level: Intermediate Important: All focus calibration procedures must be completed before performing a camera calibration to ensure accurate results. Click the tabs below to switch between machine types. Each tab shows the camera calibration procedure specific to that machine. Overview & Requirements Fusion Edge (...)
Read More
Quick Guide: Calibrating the Joystick for Accurate Movement

Quick Guide: Calibrating the Joystick for Accurate Movement

Calibrating the joystick can resolve issues like delayed movement, inaccurate control, or the carriage drifting on its own while in jog mode.

Steps to Calibrate the Joystick Open the Settings Menu On the display panel, press the gear icon in the top-right corner to open the Settings menu. Image 1: Home screen with gear icon in top-right corner Access Advanced Settings Press and hold the word “Settings” on the screen until the (...)
Read More
Fiber Alignment – Fusion Pro 32 & 48
Pro 32, Pro 48

Fiber Alignment – Fusion Pro 32 & 48

How do I align the laser in my Fusion Pro Fiber or Dual source machine.

This guide provides step-by-step instructions for performing precise laser alignment on the Fusion Pro CO2 and Fiber laser systems. Proper alignment ensures optimal engraving performance and reduces the risk of hardware damage. Whether you’re troubleshooting a drop in laser power or aligning after maintenance, this document will walk you through (...)
Read More
Touchpad Calibration – Fusion Maker, Edge, and Pro 24 and 36
Pro 24, Pro 36

Touchpad Calibration – Fusion Maker, Edge, and Pro 24 and 36

How do I calibrate the touchpad on the Fusion Maker, Edge, and Pro 24 and 36?

Estimated time: 5 minutes • Skill: Basic Touchscreen calibration ensures accurate touch response when selecting options and settings on the display. This procedure is rarely required and should only be performed if the touchscreen is registering incorrect inputs or responding inconsistently. Touchscreen Calibration Procedure Open the Settings menu. At the (...)
Read More