Skip to main content
Laser Source
8000

Filters


Getting Started (10)
Usage and Operation (94)
Service and Repair (50)

Filters


Getting Started (10)
Usage and Operation (94)
Service and Repair (50)

Low Output – Mini/Helix

What should I do if I'm experiencing low laser output on my Mini / Helix system?

Introduction

A loss of laser power on the Mini or Helix is usually caused by dirty or damaged optics, poor laser beam alignment, or a focus or table level problem. Work through the checks below in order.

Parts Required

  • None

Tools Required

  • Safety Glasses
  • Phillips Screwdriver
  • Allen Wrench (lens carriage screws)
  • Masking Tape
  • Alignment Target

1. Check the Optics

Inspect the optics for any damage: burn marks, pock marks, scratches, cracks, flaking coating or discoloration of any kind.

1Turn off and unplug the engraver.
2Look between the lens and the mirror to the back plate the carriage rides on. Remove the two small Allen screws there and lift off the whole lens carriage.
3Check the lens and the mirror above it. Clean them if they are dirty; replace any optic that is damaged.

You need to remove the lens carriage to properly see the mirror above the lens.

2. Check the Focus

Make sure the manual focus gauge and autofocus are set correctly. An out-of-focus beam engraves and cuts with less power.

Setting Manual and Auto Focus – Mini / Helix

3. Check the Table Level

If power is weak in only some areas of the table, the table may not be level, so the focus changes across the work area.

Adjusting Table Level – Mini / Helix

4. Check the Laser Alignment

If the optics, focus and table level are all good, check the laser beam alignment. Use the procedure for your engraver:

Safety First: Turn off and unplug the engraver before removing the lens carriage or any panels. Wear safety glasses whenever the laser is fired with panels removed.

Was this helpful?

Yes
No
Thanks for your feedback!
  • ID:
    ka-01021
  • Date:
    11/05/2026

Tools:

  • Safety Glasses
  • Phillips Head Screwdriver
  • Masking Tape
  • Alignment Target