Índice
- Introducción
- Seguridad
- Introducción
- Setting Up Your Laser System
- Unpacking the Fusion Ascent
- Choose Where to Locate the System
- Connecting the Exhaust
- Connecting Electrical Power
- Connecting the Laser to Your Computer
- Power on the Laser
- Set the IP Address
- Install the Software Suite & Set Up Your Laser
- Sign Up for Driver Updates and Register Your System
- Panel de control
- System Features
- Cleaning Maintenance
- Specifications
- Technical Support
- Warranty
- Configuración de materiales
- Calibration
Unpacking the Fusion Ascent
Unpack the laser system from the crate provided by Epilog. Please be sure to hold on to all packing materials and crating in case you need to move the system in the future.
1. Start by using scissors or a utility knife to cut the box straps. Stand clear of the straps, as they are under high tension and may pop out at high speed when cut.
Ahora retire el flejado y la tapa de madera de la caja.
2. Pull the box up and away from the pallet.
3. Cut the tape that’s holding the bag closed, then spread the bag over the sides of the machine.
4. If you purchased a stand with your machine and you’d like to use it as the base for your Fusion Ascent machine, assemble the stand now, before continuing on with this lesson.
5. The Fusion Ascent weight ranges from 147-212 lbs. With the help of an additional person, lift your Ascent laser system from the pallet and place it on a sturdy, level surface.
6. Once you’ve removed the machine from the pallet, remove the plastic bag.
7. You’ll find the included items and materials stored underneath:
-
Cable de alimentación
-
Cable Ethernet
-
Cable USB
-
Instalación de software USB
-
Guía de inicio rápido
-
Manual del propietario
-
Tarjeta de inscripción y kit de la suite de entrenamiento
-
Kit de muestras de materiales del proveedor
-
Limpiador de lentes
-
Diana de Laser Beam
-
Hoja de calibración de la cámara
