Fusion Ascent Suggested Material Settings (CO2)

Cutting Note: Adjusting the standard focus distance so it is closer to the lens by about .080” (2 mm) will produce better edge quality when cutting 1/4” (6 mm) acrylic and thicker. Two passes can be used for cutting thicker materials.
There are two types of acrylic: cast is better for engraving (it creates a frosted look when engraved) and extruded acrylic produces a much better flame polished edge.

Note: We find when engraving anodized aluminum, text appears best at 500 DPI, but photos and clipart can be engraved with great detail down to 400 DPI.

Note: When engraving fabric, try changing the graphic to 80% gray and use the Jarvis dithering pattern for the best results. Every fabric you are cutting will need adjusted settings — find a small swatch of the fabric you can test first.

Note: When etching glass, try changing the graphic to 80% gray before engraving and using the Jarvis dithering pattern. You can also diffuse heat by covering the glass with a thin layer of dish soap.

Note: Every marble is very different for settings. Start low and increase the power with a second run if you haven’t used that marble before.

Note: These settings work well with many plastics, including plastic phones and covers. Even one color plastics can achieve a great look when engraved.

Note: When cutting wood, multiple passes may allow cutting of thicker materials. Using Color Mapping you can adjust the focus point between passes down to the center point of the cut for the best results.