目次
- はじめに
- 安全
- はじめに
- Setting Up Your Laser System
- Unpacking the Fusion Ascent
- Choose Where to Locate the System
- Connecting the Exhaust
- Connecting Electrical Power
- Connecting the Laser to Your Computer
- Power on the Laser
- Set the IP Address
- Install the Software Suite & Set Up Your Laser
- Sign Up for Driver Updates and Register Your System
- コントロールパネル
- System Features
- Machine Maintenance
- Specifications
- Technical Support
- Warranty
- マテリアル設定
- Calibration
Cleaning the Optics on the Fusion Ascent
レンズの清掃
The focus lens is contained within the lens assembly.
Remove the cover of the lens assembly by pulling from the front handle to reveal the inside. The cover is held in place with locating pins and magnets.
-
Inside you will see the blue lens piece. Remove it from the lens assembly by carefully pulling it out by the handle. The lens is keyed so that it only goes in one way. It is held in place with magnets.
-
To clean the lens, use a high-quality cotton swab moistened with the optics cleaner supplied in the accessory kit. Please read the label on the bottle carefully.
-
Allow the optics to dry, then slide the lens back into the lens assembly, ensuring the handle is facing outward. Put the magnetic plate back onto the front of the lens assembly, ensuring the locating pins line up with the corresponding holes.
-
Put the magnetic plate back onto the front of the lens assembly, ensuring the locating pins line up with the corresponding holes.
Cleaning the Mirror on the Fusion Ascent
1. The mirror is located on the front side of the assembly and also has a simple cleaning process. Start by removing the magnetic cover on the front of the assembly by pulling from the front handle to reveal the inside.
2. Next, twist the knob on the top right side of the assembly counterclockwise to loosen the mirror, preparing it for removal.
3. Now remove the mirror from the assembly by sliding it out towards the front of the machine.
4. To clean the mirror, use a high-quality cotton swab moistened with the optics cleaner supplied in the accessory kit. Please read the label on the bottle carefully.
Wet the swab thoroughly with the solvent, and then blot it against a piece of cotton so that it is no longer soaking-wet. Then daub the lens gently, rotating the swab after each daub to expose clean cotton to the surface until the optic is free of visible contamination. At that point, prepare a fresh swab and clean the surface with a gentle zigzag motion across it. Avoid any hard “scrubbing” of the surface, especially while there are visible particles on it, and try not to use repetitive circular motions. When you are done, be careful to remove any cotton threads that may have snagged on the mountings.
