Skip to main content

16000 - Lens Removal and Installation

How do I remove and install the lens in my laser?

Date updated: 05/16/2024
Machine Series: Fusion Maker, Fusion Edge, Fusion Pro
Categories:
Key Words: Lens | Maintenance | Optics

Removal:

  1. Loosen the lens clamp with a Phillips screw driver.
    2. drawing
  2. Hold the lens tube in place to prevent it from falling out.
  3. Remove lens tube.
    4. drawing

Installation:

  1. Align slot on lens tube with rear of laser.
    2. drawing
  2. Make sure the lens is seated properly. It should lock into place and not spin.
  3. Tighten the lens tube clamp with a Phillips screw driver.
    4. drawing

If further assistance is required, please visit www.epiloglaser.com/support to contact Epilog Laser Technical Support.

Resources