Y-Axis Reducer Drive Belt Replacement -Fusion / Fusion M2
The attached PDF contains the Y-Axis reducer drive belt installation instructions.
Y-Axis Sensors
Remove Panel We’ll start by replacing the front sensor, then move on to the rear sensor. Shut off the laser and remove the power cord from the machine. Remove the top access panel on the left side of the machine by using a 5/32” hex key to turn the black (...)
Y-Axis Slider Block Install – FiberMark
Please find the attachment for an in-depth description.
Y-Axis Slider Block Install – Mini / Helix
Y-Axis slider block replacement for the Mini and Helix engravers.
Y-Motor Replacement
Remove Panels Turn off and unplug the machine. Each Fusion Edge is fitted with two Y motors. Determine which Y Motor, left or right-hand side, you will be replacing and remove that side panel from the machine. Using a 5/32″ Allen wrench, remove the 8 screws that secure the left (...)
Y-Motor Replacement
Remove Rear Panel Loosen the two screws on the back of the machine and remove the back panel. Remove Old Y-Motor Using a 3mm hex key, loosen the four hex screws located on the drive couplers located on both sides of the Y-Motor. Slide the drive couplers away from the (...)
Y-Motor Replacement
Remove Right Panel Remove the right side panel by removing the 6 screws, 4 located on the side of the machine, two located on the back of the machine. Remove Old Y-Motor Open the front access door. Locate the Y-Motor on the right hand-side of the machine. Remove the spring (...)
Y-Motor Replacement
Remove Panels Remove the top access panel on the right side of the machine by using a 5/32” hex key to turn the black panel locks ¾ of the way counter-clockwise. Use a 5/32” hex key to remove the two main panels on the back of the machine. Remove Old (...)
Z-Axis Belt Install
This procedure details steps to replacing the Z-belt. The Z-belt controls the vertical movement of the engraving table. Before starting on this procedure, raise the engraving table to the top position and disconnect the power cord from the machine. Procedure: Remove both side panels. Remove the front service panel. Remove (...)
Z-Motor / Table Motor Replacement
Adjust Table Position Start by turning on the machine and then raise the table all the way to the top. Shut off the laser and remove the power cord from the machine. To manually adjust your laser machine’s vertical table position, pull on the belt located underneath the table to (...)
Z-Motor / Table Motor Replacement
Remove Bottom Right Panel Shut off the laser and remove the power cord from the machine. Remove the bottom access panel on the right side of the machine by using a 5/32” hex key to turn the black panel locks ¾ of the way counter-clockwise. Mark Tensioning Position Begin by (...)