Top Door Gas Shock Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the top door gas shock in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis Assembly Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the x-axis assembly in the Fusion Pro 32 and 48.
Power Supply Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the power supply in the Fusion Maker, Edge, and Pro 24 and 36.
Lens Replacement
This guide provides step-by-step instructions for replacing the lens assembly in the G100 model engraver. Please review all steps carefully before beginning the procedure. Make sure the machine is powered off and the work area is prepared to avoid damage to components. If you need further assistance during or after (...)
Backplane Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the backplane board in the Fusion Pro 32 and 48.
Y-Axis Belt Replacement – 36EXT
Here are the instructions for replacing the y-axis belt on the 36EXT machine.
Y-Axis Bearing Block Assembly Replacement
This document outlines the replacement of the y-axis bearing block assembly in the Fusion Maker, Edge, and Pro 24 and 36.
Door Damper Replacement – Fusion Galvo
This guide provides step-by-step instructions for replacing the door damper on Epilog Laser G100 series systems. The procedure shown covers the replacement of the GC0233 (right side door damper), but the steps are identical for the GC0232 (left side door damper). Before starting, verify the part number on your replacement (...)
Table Switch Board Replacement
This document outlines the replacement of the CO2 laser tube in the Fusion Maker, Edge, and Pro 24 and 36. After replacing the CO2 laser tube, complete the laser alignment and focus calibration procedures.
Front Door Interlock Replacement – Fusion Pro 32 & 48
Please find the attachment for an in-depth description.
Updating the IRIS Camera System
This document outlines the IRIS camera system update procedure in the Fusion Maker, Fusion Edge, and Fusion Pro.
Autofocus Repair Guide: Replacing the Autofocus Plunger (AFP)
Estimated time: 15–20 minutes • Skill: Beginner This procedure will guide you through the process of removing and replacing the Autofocus Plunger (AFP) assembly on your laser system. The AFP is a critical component used to automatically set the correct focus distance between the laser head and the material surface. (...)