Linear Guide (IKO) Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the linear guide in the Fusion Pro 32 and 48.
Vision System Repair: Replacing the Overhead Camera
Estimated time: 30–45 minutes • Skill: Intermediate This guide outlines the procedure for replacing the overhead camera on the Epilog Fusion Pro 32 and 48 laser systems. Following these steps will ensure the camera is removed, installed, and updated correctly. For this procedure, you will need the required part: CS0834 (...)
X-Axis Idler Replacement – Fusion Maker, Edge, Pro 24 & 36
This document outlines the replacement of the x-axis idler in the Fusion Maker, Edge, and Pro 24 and 36.
Fusion Maker, Edge, Pro 24 & 36 – Linear Guide (Rev 1 IKO) Replacement
This document provides concise, step‑by‑step instructions for removing and installing the X‑Axis linear guide (IKO rail) on Fusion Edge, Maker, and Pro 24/36 engravers. Read the entire procedure before beginning, observe all safety precautions (power off and disconnect), and have the required hand tools ready. Follow each step in order (...)
Y-Axis Reducer Drive Belt Replacement -Fusion / Fusion M2
The attached PDF contains the Y-Axis reducer drive belt installation instructions.
Encoder Strip Install
The attached document will guide you through replacing the encoder strip on a 36EXT.
X-Axis Reducer Drive Replacement – Fusion Edge, Pro 24 & 36
This document outlines the replacement of the x-axis reducer in the Fusion Edge and Pro 24 and 36.
Table Belt Replacement
This document outlines the replacement of the z-axis belt in the Fusion Maker, Edge, and Pro 24 and 36.
X-Axis PCB Replacement
This document outlines the replacement of the x-axis PCB in the Fusion Maker, Edge, and Pro 24 and 36.
Encoder Reader Installation
This procedure outlines the steps necessary to replace the X-axis encoder reader on the Legend EXT machine. The X-axis encoder reader is a crucial component for accurate movement tracking of the lens carriage assembly. Over time, this part may need maintenance or replacement to ensure continued precision and smooth operation (...)
Y-Axis Home Switch Replacement
This document outlines the replacement of the y-axis home switch in the Fusion Pro 32 and 48.
Control Module Replacement
This guide provides step-by-step instructions for replacing the control board in the G100 system. Always wear an anti-static strap and disconnect power before beginning any maintenance procedure. Control Board Removal Turn off the engraver. Disconnect the power cable. Locate the door handles. Open the door. Loosen and remove screws. Loosen, (...)