X-Axis Drive Board Replacement
Please find the attachment for an in-depth description.
Checking and Leveling the Table
Estimated time: 15-20 minutes • Skill: Beginner A perfectly level engraving table is essential for accurate focusing and consistent engraving results. This guide will walk you through checking and adjusting the table level on your Epilog Mini or Helix laser system. Checking Table Level Access the table. Power on the (...)
Fan Replacement on the Epilog Mini and Helix Systems
Machine Type: Epilog Mini 18/24 and Helix Tools Needed: #2 Phillips head screwdriver, 6/32 Nut driver Flat head screwdriver or wire cutter Turn engraver off and unplug it from the wall. Face the back of the machine where the exhaust is located. Remove the 8 screws holding the back panel (...)
Cleaning Optics – Mini / Helix
Ensuring your optics are clean will help your laser system perform its best. If smoke, resin, or other contaminants are allowed to accumulate too heavily, they will reduce the available laser power and may cause damage. Dirty optics can also greatly reduce the engraving and cutting quality of your machine (...)
Y-Axis Belt Replacement – Zing
Replacing the Y-axis belt on your Epilog Zing laser machine is a straightforward process that ensures optimal performance and precision for your engraving and cutting projects. Whether you’re working with a Zing 16 or Zing 24 model, this step-by-step guide will walk you through the necessary tools and procedures to (...)
Maker X-Axis Motor Install
This document outlines the step-by-step procedure for removing and replacing the X-Axis motor in the Epilog Maker laser system. Proper handling and installation are crucial to maintaining optimal performance and avoiding damage to internal components. Please follow the instructions and diagrams carefully to ensure a smooth and successful motor replacement. (...)
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out or become damaged, which may impact the performance of your laser system. To help maintain optimal accuracy, replacement laser alignment targets are available and easy to obtain. You can purchase (...)
When to Calibrate the IRIS Camera System
Applies to: Fusion Maker • Fusion Edge • Fusion Pro • G100 All Fusion Maker, Edge, Pro, and G100 engravers are equipped with the IRIS™ camera system, which overlays your artwork onto the engraving table and material within the Epilog Dashboard software. The accuracy of this system depends on proper (...)
Setting Manual Focus and Auto Focus on the Mini/Helix
Proper focus calibration is essential for achieving consistent and high-quality results when using laser engraving machines. This step-by-step guide outlines the process for adjusting the autofocus on Epilog Mini 18/24 and Helix machines using a 4×4 piece of anodized aluminum. By following these instructions carefully, users can ensure that their (...)