Fiber Laser Replacement
This document outlines the replacement of the fiber laser in the Fusion Maker, Edge, and Pro 24 and 36. After replacing the fiber laser, complete the laser alignment and focus calibration procedures.
Backplane Board Replacement
This document provides step-by-step instructions for the removal and installation of the backplane board for Fusion Pro 24 & 36 engravers. It includes all the necessary parts, tools, and materials required for the process, as well as detailed guidance on disconnecting electrical components, handling the board with care, and reassembling (...)
Table Lead Screw Replacement
This document outlines the replacement of the lead screw in the Fusion Maker, Edge, and Pro 24 and 36.
Y-Axis Actuator Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the y-axis actuator in the Fusion pro 32 and 48.
SD Card and Coin Battery Replacement – Fusion Maker, Edge, Pro 24 & 36
This guide provides step-by-step instructions for replacing the SD card and coin battery on Fusion Maker, Edge, and Pro systems. Be sure to follow anti-static precautions and use the required tools for each step. SD Card Replacement (Fusion Maker & Edge) Control Module / SD Card Removal Turn off the (...)
X-Axis Idler Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the x-axis idler in the Fusion Pro 32 and 48.
How to Replace the CO₂ Laser Tube & RF Unit
Estimated time: 60–90 minutes • Skill: Intermediate This guide outlines the procedure for replacing CO₂ and 120-Watt laser tubes, as well as the RF unit, on Epilog laser systems. Following these steps ensures the components are removed, installed, and connected safely and correctly. For this procedure, you will need the (...)
Table Motor Replacement – Fusion Galvo
This document outlines the replacement of the z-axis motor in the Fusion Galvo.
Fiber Laser Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the fiber laser in the Fusion Pro 32 and 48.
Table Switch Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis board in the Fusion Pro 32 and 48.
Red Dot Diode Replacement – Fusion Galvo
This document outlines the replacement of the red dot diode assembly in the G100.
Vision System Repair: Replacing the Overhead Camera
Estimated time: 20–30 minutes • Skill: Intermediate This procedure guides you through removing and replacing the Overhead Camera on Fusion Edge and Fusion Pro engravers. Following these steps ensures the camera assembly is installed correctly, and the system is updated and calibrated for accurate camera-based alignment and job preview functionality. (...)