Table Motor Replacement - Fusion Maker, Edge, Pro 24 & 36

This guide covers replacing the table (z-axis) motor on the Fusion Maker, Fusion Edge and Fusion Pro 24 and 36. The motor’s position sets the table belt tension, so it is marked before removal and the new motor is lined up with that mark.

Parts Required

LC0489 – Assy, Table Motor

Tools / Materials Required

5/32" Allen Wrench
Pencil or Marker

Safety First: Ensure the engraver is completely powered off and the power cord is disconnected before removing any panels or touching internal components.

Table Motor Removal

Step 1

Turn Off Engraver

Turn off the engraver.

Step 2

Disconnect from Power

Unplug the engraver from its power source.

Step 3

Remove Right Panel

Remove the right panel of the engraver.

Step 4

Remove Front Panel and Crumb Tray

Remove the front access panel and the crumb tray of the engraver.

Step 5

Mark the Motor Position

Use a pencil or marker to mark the engraver chassis at the leading edge of the table motor (shown in red). This mark is used to set the belt tension during installation.

Step 6

Disconnect Motor Harness

Disconnect the table motor electrical harness.

Step 7

Release Belt Tension

Loosen, but do not remove, the table motor tensioner thumbscrew (circled in red) to release the tension on the table belt.

Step 8

Remove Motor Mount Screws

Loosen and remove the four 5/32" Allen screws on the table motor mount (circled in red).

Step 9

Remove the Table Motor

Remove the table motor assembly.

Table Motor Installation

Step 10

Pull the Belt Out

Pull the table belt out from the machine so it will wrap around the motor drive pulley when the new motor is installed.

Step 11

Install the New Motor

Place the new LC0489 table motor in the motor housing with the belt around its drive pulley. Install, but do not fully tighten, the four 5/32" Allen screws on the motor mount.

Step 12

Check the Lead Screw Pulleys

Make sure the table belt is still around every lead screw pulley. If it has dropped below a pulley, reposition it around the pulley.

Step 13

Tension the Belt

Tighten the tensioner thumbscrew until the leading edge of the motor lines up with the mark made in step 5.

Step 14

Tighten Motor Mount Screws

Tighten the four 5/32" Allen screws on the motor mount.

Step 15

Connect Motor Harness

Reconnect the table motor electrical harness.

Step 16

Install Crumb Tray and Panels

Install the crumb tray, the front access panel and the right side panel of the engraver.

Step 17

Power On

Reconnect the engraver to power and turn it on.

Filters