Skip to main content

Fusion Pro

16000-17000

Filters

Getting Started (11)
Usage and Operation (108)
Service and Repair (119)
Results: 237 items found
  • View:
Order by
Relevance

Filters

Getting Started (11)
Usage and Operation (108)
Service and Repair (119)
Power Supply Replacement – Fusion Pro 48 – 200 Watt
Pro 48

Power Supply Replacement – Fusion Pro 48 – 200 Watt

Step-by-step instructions for replacing the power supply in a Fusion Pro 48 200-Watt laser system.

WARNING: Servicing the power supply while the engraver is powered on can cause serious injury or damage to internal components. Always disconnect all power sources before beginning. Power Supply Removal Power OFF the system and disconnect the power cable. Remove the rear-top panel. Disconnect all electrical harnesses from the power (...)
Read More
How to Set Up Graphics Software for Epilog Laser Systems

How to Set Up Graphics Software for Epilog Laser Systems

This guide provides step-by-step instructions for configuring and using popular graphic design software with Epilog Laser systems.

Software Setup CorelDRAW Setup Open CorelDRAW. Note: CorelDRAW Graphics Suite is the recommended CorelDraw version for use with Epilog Laser systems. Other versions, such as the Student or Standard version, may have different menu options and settings. Select Tools > Options > Global > Printing > Driver Compatibility. Choose Epilog (...)
Read More
Autofocus Switch Replacement – Fusion Maker, Edge, Pro 24 & 36
Pro 24, Pro 36

Autofocus Switch Replacement – Fusion Maker, Edge, Pro 24 & 36

How do I replace the autofocus switch in the Fusion Maker, Edge, and Pro 24 and 36?

This procedure outlines the steps required to safely and effectively replace the Autofocus Switch on the Fusion Maker, Edge, and Pro, laser system. The Autofocus Switch is a critical component responsible for maintaining the proper focal distance during operation. This document provides detailed instructions to ensure proper removal, and installation (...)
Read More