Skip to main content

Table Switch Board Replacement

How do I replace the z-axis switch board in the Fusion Maker, Edge, and Pro 24 and 36?

Table / Grid :

Introduction

This document outlines the replacement of the CO2 laser tube in the Fusion Maker, Edge, and Pro 24 and 36.

After replacing the CO2 laser tube, complete the laser alignment and focus calibration procedures.

Was this helpful?

Yes
No
Thanks for your feedback!
  • ID:
    KA-01579
  • Date:
    09/24/2024

Attachments:

Continue Your Laser Journey

Revisit a past lesson or move ahead to discover what’s next!