Table des matières
- Introduction
- Sécurité
- Pour commencer
- Setting Up Your Laser System
- Unpacking the Fusion Ascent
- Choose Where to Locate the System
- Connecting the Exhaust
- Connecting Electrical Power
- Connecting the Laser to Your Computer
- Power on the Laser
- Set the IP Address
- Install the Software Suite & Set Up Your Laser
- Sign Up for Driver Updates and Register Your System
- Panneau de configuration
- System Features
- Cleaning Maintenance
- Specifications
- Technical Support
- Warranty
- Paramètres matériels
- Calibration
Setting Up Your Laser System
Setting up your Epilog Laser system is easy to do! If you’ve ever installed a paper printer, this is only slightly more difficult. The following information will help you understand the entire system and how it works.
Included Components
- Fusion Ascent Laser System
- Epilog USB thumb drive with Software Suite installation files
- USB and Ethernet Cables
- Training Suite Kit
You Will Also Need
- A computer or laptop
- An exhaust fan (mandatory): The exhaust fan is used to remove smoke and debris from the work area. The exhaust air can be ported to the outside or into a filter box.
Setup Steps
- Choose where to locate the system.
- Connect the exhaust system to your laser.
- Connect the electrical power.
- Connect the laser to your computer.
- Power on the laser and select your settings in the unboxing wizard.
- Sign up for driver updates and register your system at www.epiloglaser.com/register.
Optional Class 4 Kit
The Optional Class 4 Kit is sold separately. Contact your Epilog Distributor for more information.
Cela vous a-t-il été utile ?
Oui
Non
Merci pour vos commentaires !