Table Lead Screw Replacement
This document outlines the replacement of the lead screw in the Fusion Maker, Edge, and Pro 24 and 36.
Y-Axis Actuator Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the y-axis actuator in the Fusion pro 32 and 48.
SD Card and Coin Battery Replacement – Fusion Maker, Edge, Pro 24 & 36
This guide provides step-by-step instructions for replacing the SD card and coin battery on Fusion Maker, Edge, and Pro systems. Be sure to follow anti-static precautions and use the required tools for each step. SD Card Replacement (Fusion Maker & Edge) Control Module / SD Card Removal Turn off the (...)
X-Axis Idler Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the x-axis idler in the Fusion Pro 32 and 48.
How to Replace the CO₂ Laser Tube & RF Unit
Estimated time: 60–90 minutes • Skill: Intermediate This guide outlines the procedure for replacing CO₂ and 120-Watt laser tubes, as well as the RF unit, on Epilog laser systems. Following these steps ensures the components are removed, installed, and connected safely and correctly. For this procedure, you will need the (...)
Fiber Laser Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the fiber laser in the Fusion Pro 32 and 48.
Table Switch Board Replacement – Fusion Pro 32 & 48
This document outlines the replacement of the z-axis board in the Fusion Pro 32 and 48.
Vision System Repair: Replacing the Overhead Camera
Estimated time: 20–30 minutes • Skill: Intermediate This procedure guides you through removing and replacing the Overhead Camera on Fusion Edge and Fusion Pro engravers. Following these steps ensures the camera assembly is installed correctly, and the system is updated and calibrated for accurate camera-based alignment and job preview functionality. (...)
X-Axis Drive Board Replacement
Please find the attachment for an in-depth description.
Purchase or Print a New Laser Alignment Target
Accurate laser alignment is essential to achieving clean, precise engraving and cutting results. Over time, alignment targets can wear out or become damaged, which may impact the performance of your laser system. To help maintain optimal accuracy, replacement laser alignment targets are available and easy to obtain. You can purchase (...)
When to Calibrate the IRIS Camera System
Applies to: Fusion Maker • Fusion Edge • Fusion Pro • G100 All Fusion Maker, Edge, Pro, and G100 engravers are equipped with the IRIS™ camera system, which overlays your artwork onto the engraving table and material within the Epilog Dashboard software. The accuracy of this system depends on proper (...)